18 October 2005 | Uncategorized
After having done most of the cleaning work on the gearbox, I go ahead by reassembling brake discs and calipers. sm_189To put back the brake discs (new), I borrowed a comparator to measure the rotation defect… sm_190… it’s ok, the rotation defect is...
4 October 2005 | Mechanical, Mechanical, Mechanical, Mechanical, Mechanical, Mechanical, SM, SM, SM, SM, SM
By September 2005, I start working on the hydraulic devices. I start with the clutch cylinder and the front brake calipers: sm_203The clutch cylinder is not difficult to disassemble… sm_204… but removing the inner gasket is a nightmare, I had to use...
13 July 2005 | Uncategorized
While waiting to go ahead with the engine, I switch to the gearbox: first cleaning with gasoline, first pass with a gross metallic brush, second pass with a softer brush and then finishing with a towel full of degreaser. I found a degreasing product with an orange...
23 March 2005 | Uncategorized
I ordered many parts to the french SM Club, like valves, timing chains and engine gasket set. I will be able to start working on the engine. Anyway, I will probably give the engine to a professional to install and adjust the valves and chains. I start by cleaning...
7 February 2004 | Uncategorized
When I started the engine, everything was working but the rear suspension boots quickly began leaking. I just had enough time to drive the car out and then back in the opposite way (it’s more practical this way). sm_133We just start to have a better view and...
